Logo

C3140 Engine Code Repair

Meaning of C3140 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C3140 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C3140 code is occuring now you should check C3140 repair processes.
Now don't ask yourself; What should you do with C3140 code ?
The solution is here :

C3140 Possible Solution:

C3140 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

C3140 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

3
Ignition System Or Misfire

1
Ambient Air Temperature Sensor Circuit Low

4
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)

0
Reverse Input Circuit

Regarding the C3140 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C3140 OBD-II Diagnostic Chassis (C) Trouble Code Description

C3140 engine trouble code is about Reverse Input Circuit.

Main reason For C3140 Code

The reason of C3140 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

C3140 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.